CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL STUD BOLT |

| 2. INSTALL RING PIN |

| 3. INSTALL STRAIGHT SCREW PLUG |
Apply an adhesive to the end of the screw plug.
Using a 6 mm hexagon wrench, install the screw plug.

| 4. INSTALL SEMICIRCULAR PLUG |
Remove any old packing (FIPG) material.
Apply seal packing to the oil seal retainer as shown in the illustration.
Install the semicircular plug to the cylinder head.

| 5. INSTALL INTAKE VALVE |
![]() |
Install the valve, spring seat, compression spring and spring retainer.
Using SST, compress the compression spring and place the 2 valve spring retainer locks around the valve stem.
![]() |
Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.
| 6. INSTALL EXHAUST VALVE |
![]() |
Install the valve, spring seat, compression spring and spring retainer.
Using SST, compress the compression spring and place the 2 valve spring retainer locks around the valve stem.
![]() |
Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.
| 7. INSTALL VALVE LIFTER |
Install the valve lifter.
Check that the valve lifter rotates smoothly by hand.