Home › BODY › INTERIOR › ROOF HEADLINING (for Single Cab)

ROOF HEADLINING (for Single Cab) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT DOOR SCUFF PLATE LH


B085559E01
  1. Using a screwdriver, detach the 8 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 4 clips and remove the scuff plate.



3. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.



4. REMOVE FRONT DOOR OPENING TRIM LH


5. REMOVE FRONT DOOR OPENING TRIM RH


6. REMOVE COWL SIDE TRIM BOARD LH


B085566E02
  1. Remove the cap nut.

  1. Using a clip remover, detach the 2 clips and remove the trim board.



7. REMOVE COWL SIDE TRIM BOARD RH

HINT:
Use the same procedures described for the LH side.



8. REMOVE FRONT PILLAR GARNISH LH


B085568E01
  1. w/ Assist grip:
    Using a screwdriver, detach the 4 claws and pry out the 2 assist grip plugs.

    HINT:
    Tape the screwdriver tip before use.

  1. w/ Assist grip:
    Remove the 2 screws and the assist grip.



    B085569E01
  1. Using a clip remover, detach the 2 clips.

  1. Pull the garnish in the direction indicated by the arrow in the illustration to detach the 2 claws. Then remove the garnish.



9. REMOVE FRONT PILLAR GARNISH RH

HINT:
Use the same procedures described for the LH side.



10. REMOVE BACK PANEL GARNISH UPPER


B086202E01
  1. Using a screwdriver, detach the 4 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 5 clips and remove the garnish.



11. REMOVE QUARTER TRIM PANEL LOWER LH


    B113104
  1. Remove the bolt and disconnect the front seat outer belt's anchor.



    B085572E01
  1. Using a screwdriver, detach the claw.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 3 clips and remove the trim panel.



12. REMOVE QUARTER TRIM PANEL LOWER RH

HINT:
Use the same procedures described for the LH side.



13. REMOVE QUARTER INSIDE TRIM BOARD LH


    B086292E05
  1. Disconnect the front seat outer belt's shoulder anchor.

    1. Using a screwdriver, detach the 2 claws and open the seat belt anchor cover.

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    2. Remove the bolt and disconnect the shoulder anchor.



    B085571E01
  1. Using a clip remover, detach the 3 clips and remove the trim board.



14. REMOVE QUARTER INSIDE TRIM BOARD RH

HINT:
Use the same procedures described for the LH side.



15. REMOVE BACK PANEL TRIM (w/ Back Panel Trim)
  1. Using a clip remover, remove the 3 clips and remove the back panel trim.



16. REMOVE NO. 1 ROOM LIGHT LENS


B085012
  1. Using a screwdriver, detach the 4 claws and remove the lens.

    HINT:
    Tape the screwdriver tip before use.



17. REMOVE NO. 1 ROOM LIGHT ASSEMBLY


B085593
  1. Connect the light connector.

  1. Install the room light with the 2 screws.



18. REMOVE VISOR ASSEMBLY LH
  1. Remove the 2 screws and visor.



19. REMOVE VISOR ASSEMBLY RH
  1. Remove the 2 screws and visor.



20. REMOVE VISOR HOLDER LH


B085570E01
  1. Remove the screw.

  1. Using a screwdriver, detach the 2 claws and remove the holder.

    HINT:
    Tape the screwdriver tip before use.



21. REMOVE VISOR HOLDER RH

HINT:
Use the same procedures described for the LH side.



22. REMOVE ASSIST GRIP


B085567E01
  1. Using a screwdriver, detach the 4 claws and open the 2 covers.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the 2 screws and assist grip.



23. REMOVE ROOF HEADLINING ASSEMBLY


B113087E01
  1. Using a clip remover, remove the 5 clips and headlining.

  1. Remove the wire harness.



24. REMOVE ROOF NO. 2 SILENCER PAD


25. REMOVE SIDE RAIL SPACER FRONT LH


26. REMOVE SIDE RAIL SPACER FRONT RH


27. REMOVE SIDE RAIL SPACER REAR LH (for LHD)


28. REMOVE SIDE RAIL SPACER REAR RH (for RHD)


29. REMOVE NO. 2 SIDE RAIL SPACER REAR LH


30. REMOVE NO. 2 SIDE RAIL SPACER REAR RH