Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE RADIATOR GRILLE


B206025E01
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 screws.

  1. Put protective tape around the radiator grille.

  1. Detach the 6 claws and remove the radiator grille.



2. REMOVE FRONT NO. 1 WHEEL OPENING EXTENSION PAD (for 4WD and Pre-Runner)


B206026
  1. Remove the 2 screws and extension pad.

    HINT:
    Use the same procedures to remove the extension pad on the other side.



3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


B206027
  1. Remove the 4 screws.

  1. Using a clip remover, remove the 3 clips.

  1. Partially remove the splash shield.

    HINT:
    It is not necessary to fully remove the splash shield. Partially remove it so that the bumper cover can be removed in a later step.



4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



5. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)


B206028
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 3 bolts and engine side cover.



6. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)

HINT:
Use the same procedures described for the LH side.



7. REMOVE FRONT BUMPER COVER


B206029
  1. Remove the 2 bolts.

  1. Using a clip remover, remove the 7 clips.



    B206030E01
  1. Put protective tape around the bumper cover.

  1. Detach the 6 claws and remove the bumper cover.

  1. w/ Fog Light:
    Disconnect the 2 fog light connectors.

  1. w/ Headlight Cleaner System:
    Disconnect the headlight cleaner hose.



8. REMOVE HEADLIGHT ASSEMBLY LH


E153668
  1. Remove the 3 screws and bolt.

  1. Disconnect the connectors and remove the headlight.



9. REMOVE NO. 1 HEADLIGHT BULB


E153669
  1. Remove the socket cover.

  1. Release the lock of the set spring and remove the bulb.



10. REMOVE FRONT TURN SIGNAL LIGHT BULB


E153670
  1. Turn the bulb/socket unit in the direction indicated by the arrow and pull to remove it.

  1. Remove the bulb from the socket.



11. REMOVE CLEARANCE LIGHT BULB


E153671
  1. Turn the bulb in the direction indicated by the arrow and pull to remove it.