STARTER > REASSEMBLY |
| 1. INSTALL STARTER ARMATURE ASSEMBLY |
![]() |
Using a press, press in the armature.
| 2. INSTALL STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Align the claw of the brush holder with the claw groove of the starter yoke.
Place the brush holder on the starter yoke.
![]() |
Using a screwdriver, hold the brush spring back.
Connect the brush onto the brush holder.
Connect the 4 brushes.
Install a new O-ring to the groove of the starter yoke.
| 3. INSTALL MAGNET STARTER SWITCH ASSEMBLY |
Apply grease to the steel ball and return spring.
Install the steel ball into the starter clutch sub-assembly hole.
Insert the return spring into the magnet starter switch hole.
![]() |
Place the following parts in position on the starter housing.
| (1) | Starter clutch |
| (2) | Starter armature pinion |
| (3) | Starter idler pinion |
| (4) | Retainer |
| (5) | Clutch roller |
![]() |
Install the starter housing to the magnet switch assembly with the 2 screws.
| 4. INSTALL STARTER YOKE ASSEMBLY |
Install a new O-ring to the groove of the starter yoke.
Align the claws of the brush holder with the grooves of the magnet starter switch.
Install the starter yoke with the armature.
![]() |
Align the punch mark of the starter yoke with the line of the magnet starter switch.
Install a new O-ring to the through bolt.
![]() |
Install the 2 through bolts.
Connect the terminal C wire with the nut.