Home › ENGINE · 2KD-FTV › ENGINE CONTROL SYSTEM › INTAKE AIR TEMPERATURE SENSOR (w/o Mass Air Flow Meter)

INTAKE AIR TEMPERATURE SENSOR (w/o Mass Air Flow Meter) > INSPECTION

for Preparation Click here



1. INSPECT INTAKE AIR TEMPERATURE SENSOR



A111781E01

  1. Measure the resistance between the terminals.

    Standard resistance:
    2.32 k to 2.59 kΩ at 20°C (68°F)

    If the result is not as specified, replace the sensor.

    NOTICE:
    When checking the ECT sensor in the water, keep the terminals dry. After the check, wipe the sensor dry.