Home › ENGINE · 2KD-FTV › EMISSION CONTROL › VACUUM REGULATING VALVE (w/ EGR System without EGR Cooler)

VACUUM REGULATING VALVE (w/ EGR System without EGR Cooler) > INSPECTION

for Preparation Click here


NOTICE:
Do not remove the electric vacuum regulating valve.



1. INSPECT ELECTRIC VACUUM REGULATING VALVE (for EGR)


    A114163E01
  1. Measure the resistance of the E-VRV.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    11 to 13 Ω at 20°C (68°F)
    1 - Body Ground
    2 - Body Ground
    10 MΩ or higher

    If the result is not as specified, replace the electric vacuum regulating valve.



    A114164E01
  1. Check operation of the E-VRV.

    1. Check that air flows from port E to the filter.
      If the result is not as specified, replace the electric vacuum regulating valve.



    2. A114165E03
    3. Apply battery voltage across terminals 1 and 2.

    4. Check that air flows from port E to port F.
      If the result is not as specified, replace the electric vacuum regulating valve.