VACUUM REGULATING VALVE (w/ EGR Cooler) > INSPECTION |
| 1. INSPECT ELECTRIC VACUUM REGULATING VALVE |
![]() |
Apply a vacuum measure the resistance of the electric vacuum regulating valve (E-VRV).
| Tester Connection | Specified Condition |
| 1 - 2 | 11 to 13 Ω at 20°C (68°F) |
| 1 - Body Ground 2 - Body Ground | 10 MΩ or higher |
![]() |
Check operation of the E-VRV.
When a vacuum of 66.7 kPa (500mmHg, 19.7 in.Hg) is applied to the port E, check that air flows from port F to the filter.
If the result is not as specified, replace the electric EGR control valve assembly with E-VRV.
![]() |
Apply battery voltage across terminals 1 and 2.
Check that air flows from port F to port E.
If the result is not as specified, replace the electric EGR control valve assembly with E-VRV.