Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CLUTCH SWITCH (for LHD)

CLUTCH SWITCH (for LHD) > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH SWITCH ASSEMBLY


B184278E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed (On)
    Below 1 Ω
    1 - 2
    Not pushed (Off)
    10 kΩ or higher

    If the result is not as specified, replace the clutch switch assembly.