VANE PUMP (for 1GR-FE) > INSPECTION |
| 1. INSPECT OIL CLEARANCE |
![]() |
Using a micrometer, measure the diameter (a) of the shaft sub-assembly with pulley.
Using a caliper gauge, measure the inside diameter (b) of the vane pump housing front.
Subtract (a) from (b) to calculate the oil clearance.
| 2. INSPECT VANE PUMP ROTOR AND VANE PLATES CLEARANCE |
![]() |
Using a feeler gauge, measure the clearance between the side face of the vane pump rotor groove and the vane plates.
| Vane Pump Rotor Part No. | Vane Pump Cam Ring Part No. | Vane Plate Part No. |
| 44313-06110 | 44325-06160 | 44345-06110 |
| 44313-06120 | 44325-06170 | 44345-06120 |
| 44313-06130 | 44325-06180 | 44345-06130 |
| 44313-06140 | 44325-06190 | 44345-06140 |
| 44313-06150 | 44325-06200 | 44345-06150 |
| 3. INSPECT FLOW CONTROL VALVE |
![]() |
Check the flow control valve for leakage. Close one of the holes and apply compressed air of 392 to 490 kPa (4 to 5 kgf/cm2, 57 to 71 psi) to the hole on the opposite side. Confirm that the air does not flow out of the end holes.
![]() |
If there is leakage, replace the flow control valve.
| Vane Pump Housing Front Mark | Flow Control Valve Mark | Flow Control Valve Part No. |
| A | A | 44330-0K010 |
| B | B | 44330-0K020 |
| C | C | 44330-0K030 |
| D | D | 44330-0K040 |
| E | E | 44330-0K050 |
| F | F | 44330-0K060 |
Coat the flow control valve with power steering fluid.
![]() |
Insert the flow control valve into the flow control valve installation hole of the vane pump housing front, and check that the flow control valve enters smoothly under its own weight.
If the flow control valve does not enter the vane pump housing front smoothly, replace the flow control valve.
| 4. INSPECT COMPRESSION SPRING |
![]() |
Using a vernier caliper, measure the free length of the spring.
| 5. INSPECT PRESSURE PORT UNION SUB-ASSEMBLY |
If the union seat in the pressure port union sub-assembly is severely damaged, replace the pressure port union sub-assembly.