Home › TRANSMISSION · A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV)

AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV) > TCM Power Source Circuit

for Preparation Click here


DESCRIPTION

When the ignition switch is turned ON, battery voltage is applied to terminal IG2 of the TCM.

WIRING DIAGRAM


C190897E02


INSPECTION PROCEDURE

1.INSPECT FUSE (IGN)
A111770E01
  1. Remove the IGN fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard Resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.INSPECT IGNITION SWITCH


    C192934E01
  1. Disconnect the I6 ignition switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (AM2) - 6 (IG2)
    OFF
    10 kΩ or higher
    5 (AM2) - 6 (IG2)
    ON
    Below 1 Ω



NG
REPLACE IGNITION SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND)


    C191544E08
  1. Disconnect the T19 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T19-1 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK TCM (TCM - BATTERY)
C191543E08
  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    T17-6 (IG2) - T19-1 (E1)
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM