DTC P0101 Mass or Volume Air Flow Circuit Range / Performance Problem |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0101 | After engine is warmed up, condition (a) continues for more than 10 seconds at idling: (2 trip detection logic) (a) Mass air flow meter output more than 2.2 V | Mass air flow meter |
| Conditions (a) and (b) continue for more than 6 seconds with engine speed at 2,000 rpm or more: (2 trip detection logic) (a) VTA more than 0.1 V (b) Mass air flow meter output less than 0.25 V |
| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0101) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC.
Read DTCs.
| Display (DTC output) | Proceed to |
| P0101 and other DTCs | A |
| P0101 | B |
|
| ||||
| A | ||
| ||