Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (w/o EGR Cooler)

DTC    P0500    Vehicle Speed Sensor "A"

for Preparation Click here


DESCRIPTION

The vehicle speed sensor outputs a 4 pulse signal for every revolution of the rotor shaft, which is rotated by the transmission output shaft via the driven gear. After this signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, it is then transmitted to the ECM. The ECM determines the vehicle speed based on the frequency of these pulse signals.

G036498E01


DTC No.
DTC Detection Condition
Trouble Area
P0500
Conditions (a), (b) and (c) continue for 8 seconds or more:
(2 trip detection logic)
(a) Engine coolant temperature is more than 70°C (158°F)
(b) Engine speed is between 2000 rpm and 5000 rpm
(c) No speed signal is input to ECM
  1. Open or short in speed signal circuit
  2. Combination meter
  3. ECM
Conditions (a), (b) and (c) continue for 5 seconds or more:
(2 trip detection logic)
(a) Vehicle running
(b) Under fuel-cut operation
(c) No speed signal is input to ECM

WIRING DIAGRAM


A113745E13


INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

1.CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle.

  1. Check the speedometer reading in the combination meter.

    HINT:
    If the vehicle speed sensor signal is inaccurate, the speedometer will show abnormal readings.

    OK:
    Speedometer operates normally.



NG
CHECK SPEEDOMETER CIRCUIT
OK


2.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine and turn the tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Vehicle Speed.

  1. Check the vehicle speed at an engine speed of 2000 rpm or more while the vehicle is running.

    OK:
    Same value as actual vehicle speed.



OK
CHECK FOR INTERMITTENT PROBLEMS (Click here)
NG


3.CHECK ECM TERMINAL VOLTAGE (SPD TERMINAL)


    G036576E16
  1. While idling the engine, check the waveform of the ECM connectors using an oscilloscope.

    1. Jack up the vehicle.

    2. Move the shift lever to neutral.

    3. Turn the ignition switch ON.

    4. Check the waveform between the specified terminals of the ECM connectors as the rear wheels are turned slowly.

      OK:
      Tester Connection
      Specified Condition
      SPD (E6-17) - E1 (E7-7)
      Generated intermittently



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)