DTC P0116 Engine Coolant Temperature Circuit Range / Performance Problem |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0116 | If the engine coolant temperature was between -40°C (-40°F) and 60°C (140°F) at engine start, and condition (a) and (b) are met: (2 trip detection logic) (a) Vehicle is driven at varying speeds (accelerating and decelerating) (b) Engine coolant temperature remains within 3°C (5.4°F) of the engine starting temperature | Engine coolant temperature sensor |
| If the engine coolant temperature was more than 60°C (140°F) at engine start, and conditions (a) and (b) are met: (6 trip detection logic) (a) Vehicle is driven at varying speeds (accelerating and decelerating) (b) Engine coolant temperature remains within 1°C (1.8°F) of the engine starting temperature, and this is successively recorded 6 times |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0116 | A |
| P0116 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT THERMOSTAT |
Remove the thermostat (Click here).
Check the valve operating temperature of the thermostat.
Reinstall the thermostat (Click here).
|
| ||||
| OK | ||
| ||