Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (w/ EGR Cooler)

DTC    P0106    Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem

for Preparation Click here


DESCRIPTION

Refer to DTC P0105 .

DTC No.
DTC Detection Condition
Trouble Area
P0106
Voltage output of the manifold absolute pressure sensor is out of the standard range
(2 trip detection logic)
Manifold absolute pressure sensor

INSPECTION PROCEDURE

HINT:
If DTCs P0105, P0107, and P0108 are output simultaneously, the manifold absolute pressure sensor circuit may have an open or short. Perform troubleshooting for these DTCs first.

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0106)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Read DTCs.

    Result:

    Display (DTC Output)
    Proceed to
    P0106
    A
    P0106 and other DTCs
    B

    HINT:
    If codes other than P0106 are output, perform troubleshooting for those DTCs first.



B
GO TO DTC CHART
A

REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR