GENERATOR (for DENSO Made) > DISASSEMBLY |
| 1. REMOVE GENERATOR PULLEY CAP |
Using a screwdriver, remove the generator pulley cap from the generator pulley with clutch.
| 2. REMOVE GENERATOR PULLEY WITH CLUTCH |
![]() |
Mount the generator in a vise between aluminum plates.
Install SST (A) and (B) to the generator pulley as shown in the illustration.
![]() |
Using a wrench to hold SST (A), turn SST (B) counterclockwise to loosen the generator pulley.
Remove the generator pulley.
| 3. REMOVE GENERATOR REAR END COVER |
![]() |
Remove the 3 nuts and end cover.
![]() |
Remove the terminal insulator.
| 4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Remove the 2 screws and brush holder.
| 5. REMOVE GENERATOR COIL ASSEMBLY |
![]() |
Remove the 4 bolts.
![]() |
Using SST, remove the coil assembly.
Remove the generator washer.
| 6. REMOVE GENERATOR ROTOR ASSEMBLY |