Home › ENGINE ยท 2TR-FE › STARTING › STARTER (for 1.4 kW Type)

STARTER (for 1.4 kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER YOKE ASSEMBLY


A199399
  1. Remove the nut and disconnect the lead wire from terminal C.

  1. Remove the 2 through bolts.

  1. Pull out the starter yoke together with the armature.

  1. Remove the O-ring from the starter yoke.



2. REMOVE STARTER CLUTCH SUB-ASSEMBLY


    A199400
  1. Remove the 2 screws and magnet starter switch assembly.



    A199401E01
  1. Remove the idler gear, clutch roller, retainer and starter clutch sub-assembly from the starter drive housing.

  1. Remove the return spring.



    A115020E02
  1. Using a magnet hand, remove the steel ball from the clutch shaft hole.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    A173938
  1. Remove the 2 screws and commutator end frame from the starter yoke.

  1. Remove the O-ring from the starter yoke.



  1. Disconnect the 4 starter yoke brushes from the starter brush holder.



      A050090
    1. Using a screwdriver, pull back the spring.

    2. Disconnect the brush from the starter brush holder.

  1. Remove the starter brush holder from the starter yoke.



4. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature from the starter yoke.