STARTER (for 2.2 kW Type Denso Made) > DISASSEMBLY |
| 1. REMOVE STARTER YOKE ASSEMBLY |
![]() |
Remove the nut and disconnect the lead wire from terminal C.
![]() |
Remove the 2 bolts and 2 O-rings.
Pull out the starter yoke with the armature.
Remove the O-ring from the starter yoke.
| 2. REMOVE MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Remove the 2 screws and magnet starter switch assembly.
Remove the return spring.
Remove the pinion gear, idler gear, clutch roller, retainer and starter clutch assembly from the starter drive housing.

![]() |
Using a magnet hand, remove the steel ball from the clutch shaft hole.
![]() |
for seal type:
Remove the O-ring from the starter drive end housing.
| 3. REMOVE STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Disconnect the 4 starter yoke brushes from the brush holder.
Using a screwdriver, pull back the spring.
Disconnect the brush from the brush holder.
Remove the brush holder from the starter yoke.
| 4. REMOVE STARTER ARMATURE ASSEMBLY |
![]() |
Using a plastic-faced hammer, tap the end of the starter yoke to remove the starter armature from the starter yoke.