Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for 2.7 kW Type)

STARTER (for 2.7 kW Type) > REASSEMBLY

for Preparation Click here



1. INSTALL STARTER CLUTCH SUB-ASSEMBLY
  1. Apply high-temperature grease to the idler gear, steel ball, return spring, clutch roller and retainer.



    A197147
  1. Install the steel ball.

  1. Insert the return spring into the starter clutch hole.



  1. Install the starter clutch assembly, idler gear, retainer and clutch roller to the starter drive housing.


    A122572E02



    A102626
  1. Install the starter drive housing to the magnet starter switch with the 3 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }



2. INSTALL STARTER ARMATURE ASSEMBLY


    A071182
  1. Install the starter armature to the starter yoke.



3. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Install the starter brush holder to the starter yoke.



  1. Install the 4 starter brushes to the starter brush holder.



      A112474
    1. Using a screwdriver, pull back the spring.

    2. Install the starter brush to the starter brush holder.

      NOTICE:
      Check that the positive (+) lead wires are not grounded.



    A102628
  1. Install the commutator end frame with the 2 screws.

    Torque:
    3.6 N*m{ 37 kgf*cm , 32 in.*lbf }



4. INSTALL STARTER YOKE ASSEMBLY


    A197145
  1. Align the protrusion of the starter yoke with the groove of the magnet starter switch, and install the starter yoke and starter armature.



    A102625E01
  1. Install the 2 through bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

  1. Connect the lead wire to terminal C with the nut.

    Torque:
    24 N*m{ 245 kgf*cm , 18 in.*lbf }