DTC P1229 Fuel Pump System |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1229 | Fuel over-feed: Fuel pressure is beyond the target fuel pressure despite ECM closing suction control valve (1 trip detection logic) |
|
| Engine Speed | Fuel Pressure |
| Idling | Approximately 25000 to 35000 kPa |
| 3000 rpm (No engine load) | Approximately 50000 to 70000 kPa |
| Required sensor | Fuel pressure sensor |
| Frequency of operation | Continuous |
| Duration | 1 minute |
| MIL operation | 1 driving cycle |
| Item | Specification |
| Target fuel pressure variation | Small |
| The monitor will not run if the fuel pressure sensor, suction control valve circuit, or pressure discharge valve is malfunctioning. | |
| Detection Criteria | Threshold |
| The fuel pressure of the common rail with the suction control valve closed. | Remains higher than targeted fuel pressure |
| Behavior of the pressure discharge valve | Frequently operates |

| 1.CHECK OTHER DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P1229 | A |
| P1229 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT SUPPLY PUMP ASSEMBLY (SUCTION CONTROL VALVE) |
![]() |
Disconnect the S8 suction control valve connector.
Measure the resistance of the suction control valve.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 1.9 to 2.3 Ω |
|
| ||||
| OK | |
| 3.CHECK IF DTC OUTPUT RECURS (DTC P1229) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.
Clear the DTCs.
Disconnect the suction control valve connector and then start the engine. Wait for 1 minute.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P1229 not output | A |
| P1229 | B |
|
| ||||
| A | |
| 4.CHECK HARNESS AND CONNECTOR (SUCTION CONTROL VALVE - ECM (PROCEDURE 4)) |
![]() |
Disconnect the S8 suction control valve connector.
Disconnect the E8 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| S8-1 - PCV+ (E8-2) | Below 1 Ω |
| S8-2 - PCV- (E8-1) |
| Tester Connection | Specified Condition |
| S8-1 or PCV+ (E8-2) - Body ground | 10 kΩ or higher |
| S8-2 or PCV- (E8-1) - Body ground |
|
| ||||
| OK | |
| 5.INSPECT ECM (PCV VOLTAGE) |
![]() |
Inspect using the oscilloscope.
During cranking or idling, check the waveform between the specified terminals of the E8 ECM connector.
| Tester Connection | Specified Condition |
| PCV+ (E8-2) - PCV- (E8-1) | Correct waveform is as shown |
|
| ||||
| OK | |
| 6.CHECK IF DTCS OUTPUT RECUR |
| NEXT | ||
| ||