DTC 23 Pressure Switch Circuit |

| DTC Code | Detection Item | Trouble Area |
| 23 | When either condition below is met:
Over 3140 kPa (32.0 kgf/cm2, 455 psi) |
|

| 1.CHECK REFRIGERANT PRESSURE |
Install a manifold gauge.
Read the manifold gauge pressure when these conditions are met.
Test conditions:
|
| ||||
| OK | |
| 2.CHECK AIR CONDITIONING OPERATION |
![]() |
Disconnect the P1 switch connector.
Using a service wire, connect terminals 1 and 2 of the connector on the vehicle wire harness side.
Start the engine.
Turn the air conditioning switch ON and check the magnet clutch.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (PRESSURE SWITCH - AIR CONDITIONING AMPLIFIER AND BODY GROUND) |
![]() |
Disconnect the P1 switch connector.
Disconnect the A38 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A38-5 (PSW) - P1-2 | Always | Below 1 Ω |
| P1-1 - Body ground | ||
| A38-5 (PSW) - Body ground | Always | 10 kΩ or higher |
| P1-2 - Body ground |
| Result | Proceed to |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | A |
| OK (Checking from the DTC) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||