AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Vehicle Speed Signal Circuit |

| 1.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (SPD VOLTAGE) |
![]() |
Remove the air conditioning amplifier with its connectors still connected.
Move the shift lever to N.
Raise the vehicle.
Turn the ignition switch to ON.
Using an oscilloscope, check the waveform of the amplifier.
| Item | Content |
| Tester Connection | A37-9 (SPD) - A37-1 (GND) |
| Tool Setting | 5 V/DIV., 20 msec./DIV. |
| Condition | Engine is running and speedometer indicates speed of 20 km/h (12 mph) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the C8 meter connector.
Disconnect the A37 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C8-6 - A37-9 (SPD) | Always | Below 1 Ω |
| A37-9 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||