DTC 21 Solar Sensor Circuit |

| DTC Code | Detection Item | Trouble Area |
| 21 | Open or short in solar sensor circuit (If check is performed in a dark place, DTC 21 may be stored) |
|

| 1.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (TS VOLTAGE) |
![]() |
Remove the air conditioning amplifier with its connectors still connected.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A38-2 (S5-3) - A38-7 (TS) | Ignition switch ON Sensor subjected to electric light | 0.8 to 4.3 V |
| Ignition switch ON Sensor covered with a cloth | Below 0.8 V |
|
| ||||
| OK | ||
| ||
| 2.INSPECT A/C SOLAR SENSOR |
![]() |
Remove the solar sensor.
Measure the resistance according to the value(s) in the table below.
Connect the ohmmeter's negative (-) lead to terminal 1 and positive (+) lead to terminal 2.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Sensor is subjected to electric light | Below 10 kΩ |
| Sensor is covered with a cloth | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (A/C SOLAR SENSOR - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the A35 sensor connector.
Disconnect the A38 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A38-2 (S5-3) - A35-1 | Always | Below 1 Ω |
| A38-7 (TS) - A35-2 | ||
| A38-2 (S5-3) - Body ground | Always | 10 kΩ or higher |
| A38-7 (TS) - Body ground |
|
| ||||
| OK | ||
| ||