ECD SYSTEM (w/o EGR Cooler) > VC Output Circuit |

| 1.CHECK MIL |
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch.
|
| ||||
| NG | |
| 2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and intelligent tester ON.
Check the communication between the intelligent tester and ECM.
| Condition | Proceed to |
| Communication is not possible | A |
| Communication is possible | B |
|
| ||||
| A | |
| 3.CHECK ECM (VC VOLTAGE) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connector.
| Tester Connection | Specified Condition |
| E8-18 (VC) - E8-28 (E2) | Voltage is not 5 V |
| NEXT | |
| 4.CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the T23 throttle position sensor connector.
Turn the ignition switch ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
|
| ||||
| A | |
| 5.CHECK MIL (MANIFOLD ABSOLUTE PRESSURE SENSOR) |
Disconnect the T9 manifold absolute pressure sensor connector.
Turn the ignition switch ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
|
| ||||
| A | |
| 6.CHECK MIL (FUEL PRESSURE SENSOR) |
Disconnect the F8 fuel pressure sensor connector.
Turn the ignition switch ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
|
| ||||
| A | |
| 7.CHECK WIRE HARNESS (ECM - BODY GROUND) |
![]() |
Disconnect the T3 throttle position sensor connector.
Disconnect the T9 manifold absolute pressure sensor connector.
Disconnect the F8 fuel pressure sensor connector.
Disconnect the E7 ECM connector.
Measure the resistance of the wire harness connector.
| Tester Connection | Specified Condition |
| E8-18 (VC) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||