ECD SYSTEM (w/ EGR Cooler) > VC Output Circuit |


| 1.CHECK MIL |
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch ON.
|
| ||||
| NG | |
| 2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and intelligent tester ON.
Check the communication between the intelligent tester and ECM.
| Condition | Proceed to |
| Communication is not possible | A |
| Communication is possible | B |
|
| ||||
| A | |
| 3.CHECK ECM (VC VOLTAGE) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connector.
| Tester Connection | Specified Condition |
| E8-18 (VC) - E8-28 (E2) | Voltage is not 5 V |
| NEXT | |
| 4.CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the T2 throttle position sensor connector.
Turn the ignition switch ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
Reconnect the throttle position sensor connector.
|
| ||||
| A | |
| 5.CHECK MIL (EGR VALVE POSITION SENSOR) |
Disconnect the E2 EGR valve position sensor connector.
Turn the ignition switch ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
Disconnect the EGR valve position sensor connector.
|
| ||||
| A | |
| 6.CHECK MIL (MANIFOLD ABSOLUTE PRESSURE SENSOR) |
Disconnect the T9 manifold absolute pressure sensor connector.
Turn the ignition switch ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
Reconnect the manifold absolute pressure sensor connector.
|
| ||||
| A | |
| 7.CHECK MIL (FUEL PRESSURE SENSOR) |
Disconnect the F9 fuel pressure sensor connector.
Turn the ignition switch ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
Reconnect the fuel pressure sensor connector.
|
| ||||
| A | |
| 8.CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR) |
Disconnect the A13 accelerator pedal position sensor connector.
Turn the ignition switch ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
Reconnect the accelerator position sensor connector.
|
| ||||
| A | |
| 9.CHECK WIRE HARNESS (VC - BODY GROUND) |
![]() |
Disconnect the T2 throttle position sensor connector.
Disconnect the E2 EGR valve position sensor connector.
Disconnect the T9 manifold absolute pressure sensor connector.
Disconnect the F9 fuel pressure sensor connector.
Disconnect the A13 accelerator pedal position sensor connector.
Disconnect the E8 ECM connector.
Measure the resistance of the wire harness connector.
| Tester Connection | Specified Condition |
| E8-18 (VC) - Body ground | 10 kΩ or higher |
Reconnect the throttle position sensor connector.
Reconnect the EGR valve position sensor.
Reconnect the manifold absolute pressure sensor connector.
Reconnect the fuel pressure sensor connector.
Reconnect the accelerator pedal position sensor.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||