FOG LIGHT ASSEMBLY > ADJUSTMENT |
| 1. VEHICLE PREPARATION FOR FOG LIGHT AIMING ADJUSTMENT |
Prepare the vehicle:
| 2. PREPARATION FOR FOG LIGHT AIMING (Using a screen) |
Prepare the vehicle according to the following conditions:
Prepare a piece of thick white paper that is approximately 2 m (6.6 ft.) (height) x 4 m (13.1 ft.) (width) to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H line, V LH and V RH lines) on the screen as shown in the illustration.
H Line (fog light height): Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog light bulb center marks of the fog lights.
V LH Line, V RH Line (center mark position of LH and RH fog lights): Draw two vertical lines so that they intersect the H line at each center mark.
| 3. INSPECT FOG LIGHT AIMING |
Cover the fog light or disconnect the connector of the fog light on the opposite side to prevent light from the fog light that is not being inspected from affecting the fog light aiming inspection.
Start the engine.
Turn on the fog lights and make sure that the cutoff line is within the specified area shown in the illustration.

| 4. ADJUST FOG LIGHT AIMING |
![]() |
Adjust the fog light aim into the specified range by turning the aiming screw with a screwdriver.