Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE RADIATOR GRILLE


B206025E01
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 screws.

  1. Put protective tape around the radiator grille.

  1. Detach the 6 claws and remove the radiator grille.



2. REMOVE FRONT NO. 1 WHEEL OPENING EXTENSION PAD (for 4WD and Pre-Runner)


B206026
  1. Remove the 2 screws and extension pad.

    HINT:
    Use the same procedures to remove the extension pad on the other side.



3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


B206027
  1. Remove the 4 screws.

  1. Using a clip remover, remove the 3 clips.

  1. Partially remove the splash shield.

    HINT:
    It is not necessary to fully remove the splash shield. Partially remove it so that the bumper cover can be removed in a later step.



4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



5. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)


B206028
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 3 bolts and engine side cover.



6. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)

HINT:
Use the same procedures described for the LH side.



7. REMOVE FRONT BUMPER COVER


B206029
  1. Remove the 2 bolts.

  1. Using a clip remover, remove the 7 clips.



    B206030E01
  1. Put protective tape around the bumper cover.

  1. Detach the 6 claws and remove the bumper cover.

  1. w/ Fog Light:
    Disconnect the 2 fog light connectors.

  1. w/ Headlight Cleaner System:
    Disconnect the headlight cleaner hose.



8. REMOVE FOG LIGHT ASSEMBLY LH


E170915
  1. Disconnect the connector.

  1. Remove the 3 bolts and fog light.