THEFT DETERRENT SYSTEM > Ignition Switch Circuit |

| 1.INSPECT FUSE (ECU-IG & GAUGE) |
Remove the ECU-IG & GAUGE fuse from the instrument panel junction block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.INSPECT IGNITION SWITCH ASSEMBLY |
![]() |
Disconnect the I6 switch connector.
Measure the resistance of the ignition switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 (IG1) - 4 (AM1) | OFF, ACC | 10 kΩ or higher |
| 1 (IG1) - 4 (AM1) | ON, START | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (THEFT WARNING ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the T16 ECU connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Switch Condition | Specified Condition |
| T16-4 (IG) - Body ground | Ignition switch OFF | Below 1 V |
| T16-4 (IG) - Body ground | Ignition switch ON | 10 to 14 V |
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| T16-1 (E) - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||