Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Security Horn Circuit


DESCRIPTION

When the theft deterrent system is operating, a relay in the theft warning ECU turns ON and OFF continuously at 0.4 seconds intervals, causing the security horn to sound.

WIRING DIAGRAM


B119746E02


INSPECTION PROCEDURE

1.INSPECT SECURITY HORN ASSEMBLY
B119759
  1. Apply battery voltage to the horn and check operation of the horn.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Horn bracket
    Horn sounds



NG
REPLACE SECURITY HORN ASSEMBLY
OK


2.CHECK WIRE HARNESS (THEFT WARNING ECU - SECURITY HORN)
B119775E01
  1. Disconnect the T16 ECU connector.

  1. Disconnect the S1 horn connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T16-26 (SH-) - S1-1
    Below 1 Ω
    T16-26 (SH-) or S1-1 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY