Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Security Indicator Light Circuit


DESCRIPTION

When the theft deterrent system is in the disarmed state, the security indicator will flash continuously if the immobiliser system is set, or not illuminate if the immobiliser system is not set.
When the theft deterrent system is in the armed state, the immobiliser system is automatically set and the security indicator will flash continuously.
When the theft deterrent system is in the arming preparation state or alarm sounding state, the theft warning ECU causes the security indicator to illuminate.

WIRING DIAGRAM


B119748E02


INSPECTION PROCEDURE

1.INSPECT SECURITY INDICATOR LIGHT ASSEMBLY
B119749
  1. Remove the security indicator light.

  1. Apply battery voltage between the terminals of the indicator, and check the illumination of the security indicator.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Illuminates

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not illuminate.
    2. If the voltage is too low, the security indicator will not illuminate.



NG
REPLACE SECURITY INDICATOR LIGHT ASSEMBLY
OK


2.CHECK WIRE HARNESS (SECURITY INDICATOR LIGHT - THEFT WARNING ECU AND BODY GROUND)
B115390E01
  1. Disconnect the S10 indicator connector.

  1. Disconnect the T16 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T16-22 (IND) - S10-2 (LP)
    Below 1 Ω
    T16-22 (IND) or S10-2 (LP) - Body ground
    10 kΩ or higher
    S10-1 (E) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE