Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Driver Side Door Courtesy Switch Circuit


DESCRIPTION

The theft warning ECU detects the condition of the front door courtesy light switch (driver side).

WIRING DIAGRAM


B119753E02


INSPECTION PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY
  1. When the driver side door is opened / closed, check that the indicator in the combination meter operates normally.

    OK:
    Indicator operates normally.



NG
Go to step 3
OK


2.CHECK WIRE HARNESS (COMBINATION METER - THEFT WARNING ECU)
B115389E01
  1. Disconnect the C8 meter connector.

  1. Disconnect the T16 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    C8-17 - T16-7 (CTY)
    Below 1 Ω

  1. Measure the voltage of the wire harness side connectors.

    Standard voltage:
    Tester Connection
    Specified Condition
    C8-17 - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

3.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (FOR DRIVER SIDE)
B119755E01
  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    1 - Body ground
    Pushed (OFF)
    10 kΩ or higher



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
OK


4.CHECK WIRE HARNESS (COMBINATION METER - FRONT DOOR COURTESY LIGHT SWITCH (FOR DRIVER SIDE))
B119756E03
  1. Disconnect the C8 meter connector.

  1. Disconnect the D2 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    C8-16 - D2-1
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY