THEFT DETERRENT SYSTEM > Rear Door Courtesy Switch LH Circuit |

| 1.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (FOR REAR LH) |
![]() |
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - Body ground | Not pushed (ON) | Below 1 Ω |
| 1 - Body ground | Pushed (OFF) | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (REAR DOOR COURTESY LIGHT SWITCH (FOR REAR LH) - THEFT WARNING ECU) |
![]() |
Disconnect the D4 switch connector.
Disconnect the T16 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| D4-1 - T16-7 (CTY) | Below 1 Ω |
|
| ||||
| OK | ||
| ||