RADIATOR (w/ EGR Cooler) > REASSEMBLY |
| 1. INSTALL OIL COOLER (for Automatic Transmission) |
![]() |
Install 2 new O-rings to the oil cooler.
Install the oil cooler to the lower tank with the 2 plate washers and 2 nuts.
Install the 2 cooler pipes.
| 2. INSPECT LOCK PLATE FOR DAMAGE |
![]() |
Inspect lock plate for damage.
If the sides of the lock plate groove are deformed, reassembly of the tank will be impossible. Correct any deformations with pliers.
Water will leak if the bottom of the lock plate groove is damaged or dented. Repair or replace it if necessary.
| 3. INSTALL RADIATOR TANK UPPER AND LOWER |
![]() |
Check that there are no foreign objects in the lock plate groove, and install a new O-ring. Make sure the O-ring is not twisted.
Install the tank without damaging the O-ring.
![]() |
Tap the lock plate with a plastic-faced hammer so that there is no gap between the lock plate and the tank.
| 4. ASSEMBLE SST |
![]() |
Install the punch assembly to part A of the overhaul handle as shown in the illustration.
While gripping the handle, adjust the stopper bolt so that dimension B is as specified below.
| 5. CAULK LOCK PLATE |
![]() |
Lightly press SST against the lock plate in the order shown in the illustration. After repeating this a few times, fully caulk the lock plate by squeezing the handle until stopped by the stopper bolt.
![]() |
![]() |
![]() |
Check the lock plate height H after completing the caulking.
| 6. INSTALL RADIATOR DRAIN COCK PLUG |
Install a new O-ring to the drain plug.
Install the drain plug.
| 7. INSPECT FOR WATER LEAKS |
![]() |
Plug the inlet and outlet pipes of the radiator with SST.
Using a radiator cap tester, apply pressure to the radiator.
Submerge the radiator in water.
![]() |
Inspect for leaks.
| 8. INSTALL RADIATOR BRACKET SUB-ASSEMBLY |
![]() |
Install the 2 brackets with the 4 bolts.