Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING PANEL (for Automatic Air Conditioning System)

AIR CONDITIONING PANEL (for Automatic Air Conditioning System) > DISASSEMBLY

for Preparation Click here



1. REMOVE HEATER CONTROL AND ACCESSORY ASSEMBLY


    I043743E01
  1. Remove the 4 screws and heater control and accessory.



2. REMOVE AIR CONDITIONER PANEL SUB-ASSEMBLY


    I043744E01
  1. Remove the 4 screws.

  1. Detach the 4 claws and disconnect the heater control lower base.



3. REMOVE HEATER CONTROL BASE SUB-ASSEMBLY


    E117016
  1. Disconnect the cooler wire as shown in the illustration.



    E117017
  1. Remove the 4 screws and heater control base.

    NOTICE:
    Before performing the procedure above, the hazard switch must be turned OFF. If the switch is ON while the base is removed, damage will occur to the switch.



4. REMOVE HEATER CONTROL KNOB


    E117018
  1. Remove the 12 knobs.



5. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY


E117019
  1. Detach the 4 claws and heater control base cover.

  1. Remove the air conditioning amplifier from the air conditioner panel sub-assembly.