WIRELESS DOOR LOCK CONTROL SYSTEM (for Built-in Type Door Control Receiver) > CUSTOMIZE PARAMETERS |
| Item | Default | Contents | Setting |
| Wireless answer-back function | Only hazard warning lights flash | Function that makes hazard warning lights flash and security horn sound for answer-back when transmitter LOCK/UNLOCK switch pressed | Only hazard warning lights flash/Hazard warning lights flash and security horn sounds/OFF |
| Door ajar warning function | ON (security horn sounds) | If door is not completely closed and transmitter LOCK switch is pressed, this function sounds security horn for 1 second | ON/OFF |
| Wireless unlock operated twice function* | ON | When UNLOCK switch is pressed once, this function unlocks only driver side door. When UNLOCK switch is pressed again within 3 seconds, all doors unlock | ON/OFF |
| CUSTOMIZE WIRELESS ANSWER-BACK AND DOOR AJAR WARNING FUNCTION |
Check that the following conditions are met.
Insert the key into the ignition key cylinder, and then pull it out twice within 5 seconds (ending with key pulled out).
Wait for 5 seconds.
After completing the above step, press the transmitter LOCK and UNLOCK switch simultaneously for 3 seconds within 10 seconds.
Check that the hazard warning lights flash once.
Press the transmitter LOCK switch.
After completing the above step, press the transmitter UNLOCK switch within 2 seconds.
Check that the hazard warning lights flash once.
After completing the UNLOCK switch operation, perform the following operations (mode select) within 10 seconds.
Press the transmitter LOCK switch according to the number of times shown below to select the answer-back pattern and warning function. Press the UNLOCK switch within 2 seconds of pressing the LOCK switch.
Check the response to the customize operation.

| CUSTOMIZE WIRELESS UNLOCK OPERATED TWICE FUNCTION* |
Check that the following conditions are met.
Insert the key into the ignition key cylinder, and then pull it out twice within 5 seconds (ending with key pulled out).
Wait for 5 seconds.
After completing the above step, press the transmitter LOCK and UNLOCK switch simultaneously for 3 seconds within 10 seconds.
Check that the hazard warning lights flash once.
Press the transmitter LOCK switch 3 times within 2 seconds.
After completing the above step, press the transmitter UNLOCK switch.
Check that the hazard warning lights flash 3 times.
After completing the UNLOCK switch operation, perform the following operations (mode selection) within 10 seconds.
Press the transmitter LOCK switch according to the number of times shown below to select the wireless unlock operated twice function. Press the UNLOCK switch within 2 seconds of pressing the LOCK switch.
Check the response to the customize operation.
