Home › ENGINE ยท 5L-E › ENGINE MECHANICAL › ENGINE UNIT

ENGINE UNIT > REPLACEMENT

for Preparation Click here



1. REPLACE CONNECTING ROD SMALL END BUSH


    A057244E02
  1. Using SST and a press, press out the bushing.

    SST
    09222-54011   (09222-03016, 09222-03026)



    A056739E01
  1. Using a round file, lightly file off any roughness from the small end of the connecting rod.



    A057240E02
  1. Attach a new bush to SST with the ball of SST inside the oil hole of the bush.

    SST
    09222-54011   (09222-03021)



    A056722E02
  1. Align the oil holes of the bush and connecting rod.



    A057245E02
  1. Using SST and a press, press in the bush.

    SST
    09222-54011   (09222-03016, 09222-03026, 09222-03021)



    A057241E01
  1. Using a pin hole grinder, hone the bush to obtain the standard clearance between the bush and piston pin.



  1. Check the piston pin fit at normal room temperature.



      A057242E01
    1. Coat the piston pin with engine oil, and push it into the connecting rod with your thumb.



2. REPLACE OIL PUMP SEAL


    A057638E01
  1. Using a screwdriver, pry out the oil seal.



    A057640E02
  1. Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing belt case edge.

    SST
    09214-60010  

  1. Apply MP grease to the lip of the oil seal.



3. REPLACE ENGINE REAR OIL SEAL


    A057266E01
  1. Using a screwdriver and hammer, tap out the oil seal.



    A057639E02
  1. Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-15030  
    09950-70010   (09951-07100)

  1. Apply MP grease to the lip of the oil seal lip.