Home › ENGINE ยท 5L-E › FUEL › FUEL INJECTION PUMP

FUEL INJECTION PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL DELIVERY VALVE HOLDER


    S004413E01
  1. Install new gaskets and the valves into the distributive head.

  1. Install the springs into the delivery valve holders.

  1. Using SST, install the delivery holders.

    SST
    09260-54012   (09269-54020)

    Torque:
    59 N*m{ 602 kgf*cm , 43 ft.*lbf }



2. INSTALL DISTRIBUTIVE HEAD PLUG


    B013114E02
  1. Install a new O-ring to the distributive head plug.

  1. Using SST, install the head plug.

    SST
    09260-54012   (09262-54010)

    Torque:
    88 N*m{ 900 kgf*cm , 65 ft.*lbf }



3. INSTALL FUEL TEMPERATURE SENSOR


    B013326E01
  1. Install a new O-ring to the fuel temperature sensor.

  1. Using a 19 mm deep socket wrench, install the fuel temperature sensor.

    Torque:
    22 N*m{ 224 kgf*cm , 16 ft.*lbf }



4. INSTALL TIMING CONTROL VALVE


    B013327E01
  1. Using a 5 mm hexagon wrench, install the timing control valve with the 2 bolts.



5. INSTALL FUEL FILTER TO INJECTION PUMP FUEL PIPE


    A070790E01
  1. Install a new washer and the hollow screw.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Install the fuel pipe with 2 new washers and the cap nut.

    Torque:
    27 N*m{ 271 kgf*cm , 20 ft.*lbf }



6. INSTALL NO. 4 NOZZLE LEAKAGE PIPE
  1. Install the nozzle leakage pipe with 2 new washers and the overflow screw.

    Torque:
    27 N*m{ 271 kgf*cm , 20 ft.*lbf }