GENERATOR (for BOSCH Made) > DISASSEMBLY |
| 1. REMOVE GENERATOR PULLEY CAP |
Using a screwdriver, remove the generator pulley cap from the generator pulley with clutch.
| 2. LOOSEN GENERATOR PULLEY WITH CLUTCH |
Mount the generator assembly in a vise between aluminum plates.
![]() |
Set SST and an 8 mm bi-hexagon wrench to the pulley as shown in the illustration.
![]() |
Hold SST in place, rotate the 8 mm bi-hexagon wrench clockwise, and loosen the generator pulley with clutch.
| 3. REMOVE GENERATOR REAR END COVER |
![]() |
Remove the 2 terminal covers by turning them counterclockwise.
![]() |
Using a 15 mm socket wrench, remove the 2 nuts from the end cover.
Remove the screw and end cover.
| 4. REMOVE GENERATOR REGULATOR ASSEMBLY |
Remove the protective tower.
![]() |
Remove the 3 screws and regulator assembly.
| 5. REMOVE GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER |
![]() |
Remove the 4 screws.
![]() |
Using a screwdriver, pry off the stator.
| 6. REMOVE FITTING RING |
![]() |
| 7. REMOVE GENERATOR ROTOR ASSEMBLY |
Remove the generator pulley with clutch.
![]() |
Using a press, press out the generator rotor assembly and remove the spacer ring.