GENERATOR (for BOSCH Made) > REASSEMBLY |
| 1. INSTALL GENERATOR ROTOR ASSEMBLY |
![]() |
Set the spacer ring, drive end frame, generator rotor assembly and SST1 to SST2 as shown in the illustration.
Using SST1, SST2 and a press, slowly press the generator rotor into the drive end frame and spacer ring.
Temporarily install the generator pulley with clutch to the rotor shaft by hand.
| 2. INSTALL FITTING RING |
![]() |
Align the 3 protrustions of the fitting ring with the 3 cutouts of the generator stator with rectifier and install the fitting ring.
| 3. INSTALL GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER |
Align the key of the drive end frame with the keyway of the generator stator.
![]() |
Install the stator with the 4 bolts.
| 4. INSTALL GENERATOR REGULATOR ASSEMBLY |
![]() |
Push in the regulator by hand as shown in the illustration.
Install the regulator with the 3 screws.

Install the protective tower.
| 5. INSTALL GENERATOR REAR END COVER |
![]() |
Install the rear end cover with the 2 nuts and screw.
![]() |
Install the 2 terminal covers by turning them clockwise.
| 6. TIGHTEN GENERATOR PULLEY WITH CLUTCH |
Mount the generator assembly in a vise between aluminum plates.
![]() |
Set SST and an 8 mm bi-hexagon wrench to the pulley as shown in the illustration.
![]() |
Hold SST in place, rotate the 8 mm bi-hexagon wrench counterclockwise, and tighten the generator pulley with clutch.
| 7. INSTALL GENERATOR PULLEY CAP |
![]() |
Install a new generator pulley cap.