WIRELESS DOOR LOCK CONTROL SYSTEM (for Built-in Type Door Control Receiver) > No Answer-back |

| 1.CHECK WIRELESS DOOR LOCK CONTROL FUNCTION |
Check the wireless door lock functions by operating the transmitter switches.
| Result | Proceed to |
| Wireless door lock functions are normal but hazard warning lights' answer-back does not occur | A |
| Wireless door lock functions are normal but security horn's answer-back does not occur* | B |
| Wireless door lock functions are abnormal | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HAZARD WARNING LIGHTS |
Check that the hazard warning lights flash when the hazard warning signal switch is pressed.
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (THEFT WARNING ECU - TURN SIGNAL FLASHER RELAY) |
Disconnect the T16 ECU connector.
Disconnect the T22 relay connector.
![]() |
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| T16-23 (HAZD) - T22-8 (HAZ) | Below 1 Ω |
|
| ||||
| OK | ||
| ||