STARTER (for 1.0 kW Type) > INSPECTION |
| 1. INSPECT STARTER |
![]() |
Perform pull-in/holding test.
Disconnect the lead wire from terminal C.
Connect the battery to the starter assembly as shown in the illustration. Then check that the clutch pinion gear moves outward.
If the clutch pinion gear does not move, replace the magnet starter switch assembly.
![]() |
With the battery connected as above with the clutch pinion gear out, disconnect the negative (-) lead from terminal C. Check that the pinion gear remains out.
If the clutch pinion gear moves inward, replace the magnet starter switch assembly.
![]() |
Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns inward.
If the clutch pinion gear does not return inward, replace the magnet starter switch.
![]() |
Perform operation test without load.
Connect the lead wire to terminal C.
Mount the starter in a vise between aluminum plates.
Connect the battery and an ammeter to the starter as shown in the illustration.
Check that the starter rotates smoothly and steadily while the pinion gear is moving out. Then measure the current.
| 2. INSPECT STARTER ARMATURE ASSEMBLY |
![]() |
Check the commutator for an open circuit.
Measure the resistance between any 2 segments of the commutator.
![]() |
Check the commutator for short circuit.
Measure the resistance between each segment of the commutator and the armature coil core.
Check the commutator for dirt and/or burns on the surface.
If the surface is dirty or burnt, correct with sandpaper (No. 400) or a lathe.
![]() |
Check the commutator circle runout.
Place the commutator on V-blocks.
Using a dial gauge, measure the circle runout.
![]() |
Using a vernier caliper, measure the commutator diameter.
![]() |
Using a vernier caliper, measure the undercut depth of the commutator.
| 3. INSPECT STARTER YOKE ASSEMBLY |
![]() |
Inspect for an open circuit.
Measure the resistance between the lead wire and field coil brush lead.
![]() |
Inspect for a short circuit.
Measure the resistance between the field coil brush lead and starter yoke body.
| 4. INSPECT BRUSH LENGTH |
![]() |
Using a vernier caliper, measure the brush length.
| 5. INSPECT STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Inspect the brush insulation.
Measure the resistance between the positive (+) and negative (-) brush holders.
![]() |
Take a pull scale reading the instant the brush spring separates from the brush.
| 6. INSPECT GEAR TEETH |
Check the gear teeth on the planetary gears, internal gear and starter clutch pinion gear for wear or damage.
If a planetary gear or the internal gear is damaged, replace it.
If the starter clutch pinion gear teeth are damaged, replace the starter clutch and also inspect the flywheel ring gear for wear or damage.
| 7. INSPECT STARTER CLUTCH SUB-ASSEMBLY |
![]() |
Rotate the clutch pinion gear clockwise and check that it turns freely. Try to rotate the clutch pinion gear counterclockwise and check that it locks.
If necessary, replace the starter clutch sub-assembly.
| 8. INSPECT PLUNGER |
![]() |
Push in the plunger and check that it returns quickly to its original position.
If necessary, replace the magnetic starter switch assembly.
| 9. INSPECT MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Inspect the pull-in coil.
Measure the resistance between terminal 50 and terminal C.
![]() |
Inspect the holding coil.
Measure the resistance between terminal 50 and switch body.