AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Power Heater Switch Circuit |

| 1.INSPECT POWER HEATER SWITCH |
![]() |
Remove the power heater switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 4 - 1 | Power heater switch ON | Below 1 Ω |
| 4 - 1 | Power heater switch OFF | 10 kΩ or higher |
Apply battery voltage to the switch connector and check that the indicator light illuminates.
| Measurement Connection | Specified Condition |
| Battery positive (+) → Terminal 5 | Indicator light illuminates |
| Battery negative (-) → Terminal 8 |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BODY GROUND) |
![]() |
Remove the air conditioning amplifier with its connectors still connected.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A36-8 (HEAT) - Body ground | Ignition switch ON Power heater switch ON | Below 1 V |
| Ignition switch ON Power heater switch OFF | 11 to 14 V | |
| A36-5 (SWIN) - Body ground | Ignition switch ON Power heater switch ON | Below 1 V |
| Ignition switch ON Power heater switch OFF | 11 to 14 V |
|
| ||||
| OK | ||
| ||