Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 5L-E)

COMPRESSOR AND MAGNETIC CLUTCH (for 5L-E) > REMOVAL

for Preparation Click here



1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
SST
07110-58060   (07117-58060, 07117-58070, 07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)
  1. Start up the engine.

  1. A/C switch is ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, discharge the refrigerant gas.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE AIR CLEANER ASSEMBLY
  1. Disconnect the IAT sensor connector.

  1. Loosen the air cleaner hose clamp.

  1. Remove the 3 bolts and air cleaner.



4. REMOVE DRIVE BELT


    A121093E01
  1. Loosen the nut A and bolt B, and remove the V belt.



5. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE


    E117619
  1. Remove the bolt and disconnect the suction hose from the compressor.

  1. Remove the O-ring from the suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



6. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    E117618
  1. Remove the bolt and disconnect the discharge hose from the compressor.

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



7. REMOVE COMPRESSOR AND MAGNETIC CLUTCH


    E117620
  1. Disconnect the connector.



    E117621
  1. Remove the 4 bolts and compressor.