HEADLIGHT RELAY (w/ Daytime Running Light Control) > ON-VEHICLE INSPECTION |
| 1. INSPECT HEADLIGHT RELAY (Marking: H-LP) |
![]() |
Remove the engine room relay block cover.
Remove the headlight relay from the engine room relay block.
Inspect the headlight relay resistance.
| Terminal Connection | Specified Condition |
| 3 - 5 | 10 kΩor higher |
| 3 - 5 | Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
Install the headlight relay to the engine room relay block.
Install the engine room relay block cover.