TRANSFER CASE OIL SEAL > REPLACEMENT |
| 1. DRAIN TRANSFER OIL |
| 2. REMOVE LOWER TRANSFER CASE PROTECTOR |
![]() |
Remove the 4 bolts and protector.
| 3. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
TMT made:
Remove the front propeller shaft .
TSAM made:
Remove the front propeller shaft .
| 4. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY |
Using a chisel and hammer, loosen the staked part of the lock nut.
![]() |
Using SST to hold the companion flange, remove the lock nut.
![]() |
Using SST, remove the companion flange.
| 5. REMOVE TRANSFER CASE OIL SEAL |
![]() |
Using SST, tap out the oil seal.
| 6. INSTALL TRANSFER CASE OIL SEAL |
Coat the lip of a new oil seal with MP grease.
![]() |
Using SST and a hammer, tap in the oil seal until its surface is flush with the case upper surface.
| 7. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY |
![]() |
Apply gear oil to the connecting areas of the companion flange and driven sprocket.
Install the companion flange to the driven sprocket.
Using SST to hold the companion flange, install a new lock nut.
![]() |
Using a chisel and hammer, stake the lock nut to the driven sprocket.
| 8. INSTALL FRONT PROPELLER SHAFT ASSEMBLY |
TMT made:
Install the front propeller shaft .
TSAM made:
Install the front propeller shaft .
| 9. INSTALL LOWER TRANSFER CASE PROTECTOR |
![]() |
Install the protector with the 4 bolts.
| 10. ADD TRANSFER OIL |
Remove the case plug (for filler) and gasket.
Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the case plug (for filler) hole.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket and the case plug (for filler).