Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › EXTENSION HOUSING REAR OIL SEAL

EXTENSION HOUSING REAR OIL SEAL > REPLACEMENT

for Preparation Click here



1. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }



2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
  1. TSAM made:
    Remove the propeller with center bearing shaft .

  1. TMT made:
    Remove the propeller with center bearing shaft .



3. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


D028697E01
  1. Using SST, remove the oil seal.



4. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


G037608E01
  1. Coat the lip of a new oil seal with MP grease.

  1. Using SST and a hammer, tap in the oil seal.

    Standard oil seal depth:
    0 +-0.5 mm (0 +-0.020 in.)

    NOTICE:
    Be careful not to damage the lip of the oil seal.



5. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
  1. TSAM made:
    Install the propeller with center bearing shaft .

  1. TMT made:
    Install the propeller with center bearing shaft .



6. ADD AUTOMATIC TRANSMISSION FLUID

Fluid type:
Toyota Genuine ATF TYPE T-IV



7. CHECK AUTOMATIC TRANSMISSION FLUID
  1. Inspect the automatic transmission fluid (Click here).