Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › 5L-E CHARGING

5L-E CHARGING > SERVICE DATA



Charging circuit without load
Standard amperage: 10 A or less
Standard voltage: 13.2 to 14.8 V
Charging circuit with load
Standard amperage: 30 A or more
Brush length
Standard exposed length: 9.5 to 11.5 mm (0.374 to 0.453 in.)
Minimum exposed length: 1.5 mm (0.059 in.)
Generator rotor for open circuit
Check the rotor for circuit Standard resistance: 2.7 to 3.1 Ω at 20°C (68°F)
Check the rotor for a short circuit Standard resistance: 10 kΩ or higher
Standard slip ring diameter: 14.2 to 14.4 mm (0.559 to 0.567 in.)
Minimum slip ring diameter: 12.8 mm (0.504 in.)
Generator with vacuum pump
Maximum backlash: 1.6 mm (0.063 in.)
Drive end frame for circuit
Drive end frame for ground
Standard resistance: Below 1 Ω
Standard resistance: 10 kΩ or higher