Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT RELAY (w/ Fog Light)

FOG LIGHT RELAY (w/ Fog Light) > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK INTEGRATION RELAY (FOG RELAY)


G034545E03
  1. Using a screwdriver, detach the 2 claws, and disconnect the integration relay from the engine room junction block.

    HINT:
    Tape the screwdriver tip before use.



    G034546E01
  1. Measure the voltage of the FOG relay.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    1I-4-Body ground
    Fog light switch ON and headlight dimmer switch set to TAIL or HEAD
    10 to 14 V

    If the result is not as specified, replace the integration relay.