DTC Code
| DTC Detection Condition
| Trouble Area
|
U0073/94
| When one of the following conditions is met:
- With the IG1 terminal voltage between 10 and 17.4 V, after the output of data from the skid control ECU is completed, transmission continues for 5 seconds or more.
- The condition that the bus OFF state occurs at least once within 0.1 seconds occurs 10 times in succession. (Signals cannot be received.)
- With the IG1 terminal voltage between 10 and 17.4 V, a delay in receiving data from the yaw rate and acceleration sensor and steering angle sensor continues for 1 second or more.
- With the IG1 terminal voltage between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that a delay in receiving data from the yaw rate and acceleration sensor and steering angle sensor occurs more than once within 5 seconds.
| CAN communication system
|
U100/65
| When all conditions below are met:
- IG1 terminal voltage is between 10 and 17.4 V.
- The vehicle speed is 15 km/h (9 mph) or more.
- Data cannot be sent to or received from the ECM for 2 seconds or more.
| CAN communication system
|
U0123/62
| When either condition below is met:
- With the IG1 terminal voltage between 10 and 17.4 V, data from the yaw rate sensor cannot be received for 1 second or more.
- With the IG1 terminal voltage between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that data from the yaw rate sensor cannot be received occurs at least once within 5 seconds.
| CAN communication system
|
U0124/95
| When either condition below is met:
- With the IG1 terminal voltage between 10 and 17.4 V, data from the acceleration sensor cannot be received for 1 second or more.
- With the IG1 terminal voltage between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that data from the acceleration sensor cannot be received occurs at least once within 5 seconds.
| CAN communication system
|
U0126/63
| When either condition below is met:
- With the IG1 terminal voltage between 10 and 17.4 V, data from the steering angle sensor cannot be received for 1 second or more.
- With the IG1 terminal voltage between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that data from the steering angle sensor cannot be received occurs at least once within 5 seconds.
| CAN communication system
|