Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    43    ABS Control System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when the VSC system detects a malfunction in the anti-lock brake system.

DTC Code
DTC Detection Condition
Trouble Area
43
Malfunction in the anti-lock brake system.
Anti-lock brake system

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK ANTI-LOCK BRAKE SYSTEM
  1. Clear the DTC(s) (Click here).

  1. Turn the ignition switch to ON.

  1. Check if the same DTC is recorded (Click here).

    Result 
    Result
    Proceed to
    DTC relating to anti-lock brake system not output
    A
    DTC relating to anti-lock brake system output
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
A


2.RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Clear the DTC(s) (Click here).

  1. Start the engine.

  1. Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

  1. Check if the same DTC is recorded (Click here).

    Result 
    Result
    Proceed to
    DTC 43 not output
    A
    DTC 43 output
    B



B
REPLACE BRAKE ACTUATOR ASSEMBLY
A

CHECK FOR INTERMITTENT PROBLEMS