FUEL SUPPLY PUMP (w/ EGR Cooler) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 4 bolts and under cover.
| 3. REMOVE NO. 2 ENGINE UNDER COVER |
Remove the 2 bolts and under cover.
| 4. LOOSEN FUEL TANK CAP ASSEMBLY |
| 5. DRAIN FUEL |
| 6. DRAIN AUTOMATIC TRANSMISSION FLUID |
| 7. DRAIN RADIATOR ASSEMBLY |
Remove the radiator assembly. (Click here)
| 8. REMOVE TIMING BELT |
Remove the No.1 timing belt. (Click here)
| 9. REMOVE FUEL INLET PIPE SUB-ASSEMBLY |
![]() |
Remove the bolt and clamp.
![]() |
Remove the bolt and oil level gauge guide.
![]() |
Using a 17 mm union nut wrench, loosen the union nuts and remove the fuel inlet pipe.
| 10. REMOVE SUPPLY PUMP ASSEMBLY |
![]() |
Disconnect the 2 fuel hoses.
![]() |
Disconnect the 2 connectors.
![]() |
Remove the 4 bolts indicated by the arrows in the illustration.
Remove the No. 2 camshaft timing pulley flange and pump drive shaft pulley.
![]() |
Remove the set nut and O-ring while holding the crankshaft pulley by using SST.
![]() |
Loosen the 2 nuts.
![]() |
Using SST, disconnect the pump from the injection gear.
Remove the 2 nuts and pump.
Remove the O-ring.